Search Results:

The Brother Binding Foot attaches bias tape with widths less than 7mm (1/4 inch) using straight, zigzag or decorative stitches.

  1. Before attaching the presser foot, insert the bias tape into the funnel guide to match the tape edge to the guide side.
  2. Pull the tape from the rear of the presser foot.
  3. Snap on the presser foot.
  4. Adjust the needle position so that the needle lines up to the edge of the bias tape.

Hint: If the needle does not position properly on the bias tape, loosen the position knob on the foot to slide the guide to the left or right.


Barcode: 4977766604390

More From This Category

Your Browsing History